 |
||||||||||||||||||||
 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
 |
||||||||||||||||||||
|
||||||||||||||||||||
 |
||||||||||||||||||||
 |
||||||||||||||||||||
 |
||||||||||||||||||||
 |
||||||||||||||||||||
|
If you want to install a custom taillight and turn signals but don’t want to deal with wiring issues, these are the products for you! We’ve built our own rear wiring harness and front signal interconnects to make customizing a snap. This taillight / turn signal rear wiring kit plugs directly into the bike’s main harness and has female bullet connectors that will accept just about any after market light with male bullets. It also has a ground ring terminal for installing two wire taillights. Color coded wires make for easy installations. We’re now wiring these kits to accommodate dual filament signals which will allow you to use running lights on the rear! The front signal wiring interconnect easily converts signals with male bullet style connectors to the OE style. By using both front and rear wiring pieces, you can change the taillight and all four signals without a single wire being cut! Front Signal Wiring Interconnects Fits Triumph Bonneville, T100, SE, Scrambler and Thruxton The standard configuration of the rear harness is setup for the use of turn signals installed at the shock mounts. Longer, custom lengths are available by request. |
||||||||||||||||||||
 |
||||||||||||||||||||
|
|
||||||||||||||||||||
